|
|
#2
13-10-05, 05:06
|
|||
|
|||
Nice work......
How did you do it Phil.....???
Just a cut with the 4 1/2 grinder???? any problem with relocating the stud ball for the fork???? GM did make some recent modern right hand side clutch beel housing for vans in the 70s I beleive....clutch was on right side and operated with slave cylinder from clutch master system... would be of interest if one wanted to instal a 350 V8..... not sure if they had one for the six in line at that time.... Good work...... Bob C
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode