|
|
#35
08-12-25, 20:08
|
|||
|
|||
Switchboards Charging No. 5C Mk I Canadian
The remaining 0BA Brass hardware I needed to replace what was missing on my Switchboard arrived in this mornings Post from BA Bolts in the UK.
I now have a section of 0BA threaded stud to cut the two missing terminals from. a large supply of the half thick brass hex nuts and the standard hex nuts to go along with the washers purchased earlier. I just have to start over with new Nickel plates and a fresh batch of solution and I will be good to go a few steps further on this part of the project. David Last edited by David Dunlop; Today at 00:59. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Canadian staff car wireless: World War 2 Canadian R103 Receiver Demo | Mike K | The Wireless Forum | 5 | 24-07-16 16:20 |
| Found: CMP Wireless body project | Jim Burrill | For Sale Or Wanted | 7 | 05-04-15 01:02 |
| Canadian dehavilland mosquito restoration project | David Dunlop | WW2 Military History & Equipment | 9 | 10-07-14 01:51 |
| Canadian project | David Ellery | The Carrier Forum | 9 | 28-04-07 02:36 |
| FOR SALE/TRADE: 1944 CHOREHORSE PROJECT for Signal Corps Wireless Power Unit Project | Alain | For Sale Or Wanted | 1 | 21-02-07 01:11 |
Threaded Mode