Derk’s new Universal carrier Mk 1*

[derk derin]

I had one item missing on my carrier that I needed to install my convoy light setup. It was the 90 degree elbow on the conduit that has the wiring run through the access plate through the flexible metal conduit to the light housing.
Well my good friend dug through his pile of parts and amazing as it was, he had one! I’m all set. Just have to source a section of flexible conduit to run the wiring through.

[derk derin]

I have a question about the front junction box located at the front left ammunition bin on the carrier. It has 2 plugs coming out of it for 2 headsets. One is obviously for the Gunner/commander. Was there a headset for the driver as well for I.C. Communicating with the rest of the crew? If so, it would have run off of a headset extension to the drivers side of the carrier?

[Ron Pier]

When I fitted my axle flood lamp many years ago, I got my switch and change over labels from https://www.lwdparts.com/

They still have them I think. Ron

[derk derin]

Perfect, thanks Ron, I was just thinking about the switch and labels. I have a switch in the pile of spare parts from Dave but I need to find the RED/WHITE labels. I’ll check Dirk’s site for them.
Cheers,Derk

[Petr Brezina]

Originally Posted by derk derin

I have a question about the front junction box located at the front left ammunition bin on the carrier. It has 2 plugs coming out of it for 2 headsets. One is obviously for the Gunner/commander. Was there a headset for the driver as well for I.C. Communicating with the rest of the crew? If so, it would have run off of a headset extension to the drivers side of the carrier?

Yes Derk, thats correct

[Ron Pier]

I found this in Ford Canada Trucks, maybe he still has them separate?
https://www.lwdparts.com/product/pla...-tail-sublamp/

Ron

[derk derin]

I fabricated a second A set antenna base for my carrier and at the same time cleaned up and fixed my antenna mount I built over 20 years ago that I made a few mistakes on that are now somewhat corrected. Not perfect but presentable!
It sure helped having a hydraulic press to use this time. I made a few sets of tooling out of angle iron and flat stock to make the bends which worked perfect for me.

[derk derin]

Getting them mounted on the carrier sure added to the look. I’ve also made the B set antenna mount and just finishing up the fitting of it to the carrier.

[derk derin]

Here’s a dirty job I started. Grinding off years of rust & old paint! My arms & hands can only take so much each day so it’s going to take me awhile to get it ready to prime & paint. Lucky I’m retired and in no rush!