![]() |
|
#1
|
|||
|
|||
![]()
Sorry Robert; I didn't know you had one in the yard, I thought you were just basing it on the black and white picture.
In that case it seems there were at least two different interior colours used; silver and white. I also noted there are differences in the position of the seat and water tank in these bodies, but haven't checked Clive's book yet to see if it's in there. Sometimes the water tank is left and the seat on the right, sometimes it's mirrored. At first I though the factory pictures might have been mirrored, but judging from the axle this doesn't seem to be the case
__________________
Chevrolet C8 cab 11 FFW BSA Folding Bicycle |
#2
|
||||
|
||||
![]()
I just went outside to the Ambulance box and at first glance it has a Silver paint job inside but looking closer underneath the silver paint you can see there is white paint. From there it is the thin Red pressboard that the interior is sheeted with. So I would say the interior was originally white from the factory. At some point my box was painted silver, both inside and outside so somebody wanted to give it a new paint job to clean it up!
The inside of the doors are painted the same green colour as the outside of the vehicle. The doors when swung all the way open could be secured by a lower latch on the bottom of the ambulance body and held to the side of the body.
__________________
1942 Ford universal carrier Mk 1 1943 Ford 60 cwt long CMP ambulance 1943 Ford GPW 1/4 ton stretcher jeep 1943 Bantam T-3 1/4 ton trailer BSA folding airborne bicycle ser#R5325 (early) |
#3
|
||||
|
||||
![]()
As for the different interior layouts of the bodies according to my manuals the ambulance body styles 3F1 and 3G1 had the blanket locker with water tank on top at the Left of the front of the body with the attendants seat on the right side up front.
__________________
1942 Ford universal carrier Mk 1 1943 Ford 60 cwt long CMP ambulance 1943 Ford GPW 1/4 ton stretcher jeep 1943 Bantam T-3 1/4 ton trailer BSA folding airborne bicycle ser#R5325 (early) |
#4
|
||||
|
||||
![]()
The Ambulance body 3G2 had the exterior water heater mounted to the right side of the body so they reversed the layout so the water tank was on the right front corner of the box.
__________________
1942 Ford universal carrier Mk 1 1943 Ford 60 cwt long CMP ambulance 1943 Ford GPW 1/4 ton stretcher jeep 1943 Bantam T-3 1/4 ton trailer BSA folding airborne bicycle ser#R5325 (early) |
#5
|
||||
|
||||
![]()
The 3G2 model Ambulance box.
__________________
1942 Ford universal carrier Mk 1 1943 Ford 60 cwt long CMP ambulance 1943 Ford GPW 1/4 ton stretcher jeep 1943 Bantam T-3 1/4 ton trailer BSA folding airborne bicycle ser#R5325 (early) |
#6
|
||||
|
||||
![]()
The 3G1 ambulance had a recirculator, (whatever that is?)
I see in the picture that the water tank is square. That may have a special water system?
__________________
1942 Ford universal carrier Mk 1 1943 Ford 60 cwt long CMP ambulance 1943 Ford GPW 1/4 ton stretcher jeep 1943 Bantam T-3 1/4 ton trailer BSA folding airborne bicycle ser#R5325 (early) |
#7
|
||||
|
||||
![]()
And one more Ambulance body manual I have is a Tropic-Proofed Ambulance body Model 3G5
__________________
1942 Ford universal carrier Mk 1 1943 Ford 60 cwt long CMP ambulance 1943 Ford GPW 1/4 ton stretcher jeep 1943 Bantam T-3 1/4 ton trailer BSA folding airborne bicycle ser#R5325 (early) |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
C8A HUW: body dimensional data needed | Jerry Hill | The Restoration Forum | 53 | 30-08-15 20:23 |
photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 06:29 |
austin k2y ambulance body | rupert condick | The Restoration Forum | 2 | 28-11-09 01:50 |
Ford 15A 2B1 Body: help needed | Fabio | The Softskin Forum | 7 | 14-10-08 21:40 |
Australian CMP Ambulance body | Rusty | For Sale Or Wanted | 0 | 10-07-06 07:46 |