M135 CDN, 6X6 Truck................

[Chris Preston]

Many Thanks Rob and Peter. This is a big help.

Cheers,

Chris

[rob love]

For the curved top bows, you should have no problem getting top bows for the M35 out of the USA. As I mentioned, they just need to be cut back a little to work. For the corners, which are metal, I may have squirreled away far too many of them at the Shilo museum. A transfer can be made museum to museum, just your end would be responsible for the postage. I also have squirreled away lots of the metal stakes and seat hardware, again a transfer can be made.

If you know of a truck going through, we could likely set you up with the just about all you would need for the complete setup.


People previous to me used spruce for a lot of the bows etc on the museum vehicles. Don't bother...it is just a waste of wood as it will break whenever you don't want it to.

[Chris Preston]

Hi Rob,

Many Thanks for the offer to assist. We still have to do a full assessment of the vehicle. Once done. I'll get back to you and what we might need.

Thanks again.

Chris, in Victoria, BC