Quote:
Originally Posted by Robert Bergeron
Our common friend and contributor par excellence David Dunlop had asked the question back in 2017 : How do you know where to drill the holes in the table top to install the different radio carriers ? A : A Masonite board came screwed to the top with all the possible holes pre-drilled to accomodate the different carriers . No written instructions in the installation manual . The Masonite acts as a mask or template . Much better than words ! I recently acquired this original table from another unit that was located in New Brunswick but that came from Ontario .The Masonite is in good enough condition to reuse it . Underneath is a perfectly usable 3/4 inch plywood . Voilà ! Mystery solved.
|
That masonite sheet needs to be preserved (and documented) for posterity!
I wonder if anyone has a plan or map scanner big enough to produce a 1:1 copy on paper? (Then you just need to work out which holes correspond to which set carrier!)
Chris.
02-03-21, 01:15
Similar Threads
Threaded Mode