Looking for a CFTO - M38A1 CDN windshield washer

[rob love]

The CFTO is not in the C30-100 series where the Jeep mods would normally be found. Rather it was a modification in the C30-010 series, which was more general for the SMPs, and that particular modification covered the Jeep, the 3/4, the old deuce and the 5 ton if I remember correctly.

I'll have a look at my holdings and see if I have it, but I don't have all the C30-010 series...just smatterings of them.

It was the same kit supplied for all the M-series, held under a Cdn NSN.

[Wayne Hingley]

Rick: I don't have the CFTO, but if Rob isn't able to locate it, I can help by providing actual measurements, locations etc if needed.

I have seen two different reservoir types for the washer fluid: the bag style, and a cylindrical rigid plastic tank. Otherwise, to my knowledge the remainder of the components are the same. With M38A1's I have also seen mainly 2 variations of where the squirt nozzles are located on the hood or cowl. It will be interesting to see what the CFTO specifies.

I suppose the performance of the squirt pump is subject to a lot of variability as noted by Terry, but the ones I have had work very well in terms of pumping out a strong, full stream with each pump. If not aimed correctly, the stream will shoot right over the top of the windshield. Practical performance however, considering the near vertical windshield and the usual performance of the vacuum wipers, isn't exactly what you get in your average modern car.

[rick25]

Thank you, I purchased the kit years ago. It carries Trico part number AWL8-1AL with a NSN of 2540-21-xxxx-6085 (where the x’s are unreadable). It was packed by Mil-quip in 1985. The squirter nozzle is the style that mounts to the cowl.

[maple_leaf_eh]

Originally Posted by rick25

Thank you, I purchased the kit years ago. It carries Trico part number AWL8-1AL with a NSN of 2540-21-xxxx-6085 (where the x’s are unreadable). It was packed by Mil-quip in 1985. The squirter nozzle is the style that mounts to the cowl.

That looks like the plastic one I had that broke.

[Robin Craig]

what wonderful information and knowledge

[maple_leaf_eh]

I did some Goofle searching with the company name and various key words. The manually operated pumps don't seem to be a thing anymore. Lots of generic offerings for electrically driven one though.

Maybe Trico has a similar generic one in the catalogues, but named something else?

[Wayne Hingley]

For reference; here is an example of the rigid plastic fluid reservoir. I estimate the capacity to be approximately one liter, maybe a bit more.