Chore Horse Wiring Diagram

[Chris Suslowicz]

Originally Posted by stephen crowhurst

Thanks Chris, the wire from the starter winding that connects to the Start button was one of the wires dissed off when I got the chore horse.
I take it that the rheostat connects to earth through its body too the casing?
Cheers Stephen

Correct. The shunt field winding connects to the end of the resistance track, and the wiper arm is earthed to the casing. The resistance then controls the current through the field winding and that determines the strength of the magnetic field and hence the generator output voltage.

The start button connects a series field winding between the positive battery terminal and the positive brushes on the armature. That turns the generator into an electric motor to crank the engine when the button is pressed. (If the battery can't supply enough current to turn the engine over you have to resort to the cord and pulley method.)

Best regards,
Chris.

[stephen crowhurst]

Thanks Chris, I take it that the Amp meter should be 30A each way on the chore horse, that's all I can see in every picture I can find.
Cheers Stephen,

[Chris Suslowicz]

Originally Posted by stephen crowhurst

Thanks Chris, I take it that the Amp meter should be 30A each way on the chore horse, that's all I can see in every picture I can find.
Cheers Stephen,

The BSA charging set uses a Lucas 30-0-30 Amp 1.5 inch diameter meter, I suspect the original is very similar. (The generator is rated at 20 Amps output.)

Doc 299 in the 19 set group archive is a post-WW2 chore horse manual from "Threestokes" (Stokes, Stokes & Stokes Ltd.) which goes into a fair amount of detail on dismantling and reassembly of the unit, plus operation, parts lists, etc.

Best,
Chris.

[stephen crowhurst]

Thanks Chris for all your help, I will see if I can find a suitable Amp meter.

Cheers Stephen