Wireless Set No. 52 Canadian - Project

[David Dunlop]

I have been taking a bit of a break from receiver work today and taking a closer look at the Carriers No. 4 assembly to better sort out the work it will need down the road.

While Jacques Fortin had been keeping watch over the set for me prior to shipping it West, he had noticed all three components took a bit of grunt work to get in and out of the Carriers. A large part of this was attributable to the shear weight of at least the Supply Unit and Sender bearing down on the painted interior surfaces of the bottom of the compartments. Any dirt on the bottom chassis rails of the components really dug into the paint and there was no sense of 'slide' whatsoever. My short term thought on this is to strip the paint chemically from the bottom of the compartments to hopefully reveal the original factory satin nickel plating.

The other point of concern ws the snug fit of the Receiver into its compartment along the sides. While taking a closer look at this issue today, I discovered the left side panel of the receiver compartment bulges into the compartment right at the point where the left side mounting screw locates. I at first thought the problem was an overtightened screw at some point in time that drew the side panel in, but a close look suggests this is unlikely. The mounting screw passes through the side panel skin and starts threading into the steel reinforcing bar located around the outer edges of the panel. It then continues into the front guide bar assembly for the retracting carry handle which takes up all of the load of the screw. Looks like it should be an easy fix, however. Next time the receiver is out of the Carriers, I should be able to tap the bulge back flat to prevent the panel from binding on the receiver mounting bracket and upper panel assembly.

David