Amplifier Rack

[Bruce Parker (RIP)]

The angle is 1.5" by 1/8". The corner gussets are 1/8" plate and the four corner front/back angles are bent 1/8" plate as well (they are not symetical...one side is longer than the other and the tops and bottoms are different). Additionally there are two channel stiffeners on the top between the front and back angles.

If you want I can sketch up dimensions and construction details for you.

[Barry Churcher]

That would be awesome Bruce. Thank you very much.
Barry

[Johnny Canuck]

Hello Barry and Bruce also.
I'm in Ottawa if you want see the actual frame. LMK.

Geoff

[Bruce Parker (RIP)]

Let me know if this make sense. I can take some pics that might clarify things and show where the welds are, etc.

[Barry Churcher]

Thanks for the incredibly detailed drawings Bruce. I sure appreciate the effort you must have gone to.
Cheers,
Barry

[Barry Churcher]

Bruce, I am back to the well again. I started the build on this before Covid and I am now ready to get back at it. I wish I could have taken Geoff up on his offer to see his in person. What a monster. When you see photos and read the measurements you still don't visualize how big this thing is. I may have to add another leaf to the springs on the C15TA. I have a couple of questions on the measurements that I just can't quite make out. How is the angle on the very top ,shown with arrow, attached? Also the area circled is very faint and I can't quite decipher it. After the work you put into the detailed plan I don't want to screw up the build. The last question is about the paint. In some photos it looks to be painted with the pebbly finish similar to the radio cases. Is that the case and has anyone found a source for that? Thanks very much.
Barry

BRUCE-A.jpg