Carrier mufflers??

[rob love]

Some of the technical info from these mufflers:

Body Configuration: Offset - Offset
Body Cross Section Diameter: 6"
Body Length: 17 in
Inlet Configuration: Offset
Muffler Body Height (in): 6 in.
Muffler Body Width (in): 6 in.
Muffler Inlet Connection Type: Pipe Connection
Muffler Inlet Count: 1
Muffler Inlet Diameter 1 (in): 1 1/2"
Muffler Inlet Diameter Designation: I.D.
Muffler Inlet I.D.: 1 1/2"
Muffler Material: Steel
Muffler Outlet Connection Type: Pipe Connection
Muffler Outlet Count: 1
Muffler Outlet Diameter (in): 1 1/2"
Muffler Outlet Diameter Designation: I.D.
Muffler Outlet I.D.: 1 1/2"
Muffler Shape: Round
Outlet Configuration: Offset
Overall Length: 24 in.
Reversible: No
Shell Length: 17"
UNSPSC: 25173702

Note the info on "reversible". Then again, I am not sure if I directed the ones I have used (I have done 3 different carriers in the past few years using these mufflers). All are nice and quiet. I did drill a drain hole in the low spot of the mufflers as well as the pipes to allow water condensation to escape.