|
|
#8
15-10-18, 00:48
|
|||
|
|||
The stiffener can be seen in the illustration Michael R. shows above as part number CTL13451. It helps support CTL 13250 from stressing and breaking the mounting ears off the top plate of the transmission.
Re the bolts, that is all I have ever seen, whether late or early Cdn carrriers. There should be two bolts at each end. They are shown in the photo as TL156. I have had to make adjustments before to the linkage, although it is not designed to be adjusted. I made my adjustment by heating and bending the cast arm with the ball on it that comes up form the shifter rod. But in your case, I think I would determine if the indexing of the 3 part shifter rod is correct and all 4 bolts are in place. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Advice on lashing down a carrier | Darrin Wright | The Carrier Forum | 17 | 10-03-15 21:32 |
| Carrier wheels...need advice. | Bob Carriere | The Carrier Forum | 2 | 15-08-10 22:51 |
| Advice on first carrier | Ben | The Carrier Forum | 8 | 10-07-10 18:57 |
| Any advice for first time driving of carrier | Jordan Baker | The Carrier Forum | 11 | 21-05-04 17:06 |
| Carrier engine problem | Jim Burrill | The Carrier Forum | 10 | 10-10-03 04:21 |
Threaded Mode