![]() |
#6
|
||||
|
||||
![]()
That’s a lot of welding to do and make it look good from both the outside and inside on some pretty thin sheet. When I was redoing my roof I initially thought to do what you guys are doing. However I found it easier to simply replace the entire panel. I slowly ground down the spot welds along the top edge from the inside. Hen just popped the panel off.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
2016 at the Hammond Barn | RHClarke | The Restoration Forum | 83 | 08-01-17 18:22 |
2015 at the Hammond Barn | RHClarke | The Restoration Forum | 113 | 31-12-15 21:00 |
2010 at the Hammond Barn | RHClarke | The Restoration Forum | 181 | 01-01-11 03:02 |
2009 at the Hammond Barn | RHClarke | The Restoration Forum | 322 | 02-01-10 16:05 |
Hammond Barn Visit | Wpns 421 | The Softskin Forum | 1 | 15-12-09 03:17 |