Early M38A1 CDN Info

[maple_leaf_eh]

Good luck correcting the museum. They probably know from other visitors like you that there is a mistake, but have other issues to fix before changing a label.

[Les Kovacs]

Thanks for the info Rob.....here is a pic of the Borden M38A1.....try to zoom and read the description on the stand.

lesk

[Wayne Hingley]

Originally Posted by Les Kovacs

Thanks for the info Rob.....here is a pic of the Borden M38A1.....try to zoom and read the description on the stand.

lesk

Here is a closer image with a bit or manipulation... Its definitely a "Dodge Jeep", or in french its a "Jeep Dodge".

[Les Kovacs]

Hi Rob.....with your suggestion I was able to finally post the picture of the Borden M38A1 CDN by resizing the jpegs via the pixel count through "paint" as you had suggested. Now, after all these months I am able to finally post some pictures of the 67' Jeep I have been working on with your help as well as others from MLU.

Thanks!

lesk

[Les Kovacs]

Wow....thanks Wayne....never knew that you can enhance jepgs that much.

lesk

[rob love]

Very clean truck. What is with the double fuel filters though?

If you are after the proper "accordian" type air intake hose, I believe you can get them from Rod Shaver in the US. I bought a couple off ebay a few years back (and postage to Canada was very very cheap) and believe it was from him.

[Les Kovacs]

Hi Rob....thanks for the reply.....the jeep looks and drives good because of my much too frequent cry for help on MLU and your eagerness to help me out.

The engine pics were taken this summer probably about two week after I purchased the jeep. Since that time I have removed the air (rad) hose and replaced it with a proper accordion type hose from Brian Asbury. The upper fuel filter was also taken out as I have plumbed one before the fuel pump directly below the radiator.....I also did not know that the glass bowl was a filter....I just though that it was a sediment bowl and I wanted something finer.

Right now I have gotten back my 3 row re-cored rad and I am in the process of painting it....as well as replacing the bellcrank hardware as per your help in previous posts before the rad is reinstalled.

I am searching for an upper FN C1 clip as well as a lower butt cradle.....any suggestions as where to look?

Regards,

lesk