An Introduction: Chris Collins and Morris Tilly Project

[jack neville]

The floor is now welded in, which just left the small patch to do. The patch needed to match the cut off ends of the rotted floor ribs so after welding a flat patch in I heated it up and gently tapped the profile of the ribs in where required. Needs a little more dressing with a hammer and dolly but I can't access it properly in this position so I will finish it off when I can turn the chassis on its side. A few heat shrinks were required also to pull the front area of the floor into better shape and there are just a few welds to grind up.

[colin jones]

Fantastic job there Jack. This is a part of all the hard work that is not seen when it's finished. With all the photos taken with peoples different job it is a great guide and documentation for other people to see as well.

[jack neville]

Thanks Colin. Yes I'm just thankful it is a little car that can be easily tossed around to make the work easier. So far I don't think it has suffered from any heat distortion.

[jack neville]

Rooves have been blasted and the original just needs a small patch where it had been previously rusted through and filled. The folds inside above the sills are a bit untidy but will be convered with masonite trim eventually so we can live with that.

Chris has started working on the body side panels marking and drilling holes.

[Chris Collins]

Caught in the act... see i do stuff!

[jack neville]

Whilst Mr Collins concentrated on marking holes I spent some time grinding up the welds on the additions to the chassis.
Measured up requirements for the tow bar which I will make up once I get the required steel.
Rear section is now ready to seal and paint. I think.

[jack neville]

Pictures of the rooves as earlier mentioned. First was to add the rib on the car roof to match the original Tilly. There is a piece of rope which fits between to rib and roof to stop vibration I suppose. Some grinding of the rib to allow access to the bolts securing the supporting timber strut. Also reattached the small gutter pieces to the car roof.