|
|
#10
22-12-16, 19:05
|
|||
|
|||
The power supply I'm using is the one (photo #4) that Bruce posted. It is a psu that supplies the necessary HT & LT to the set. It was made for the military, mine is dated from the 1950s.
The CPP2 only provides 12V or 24V to power the normal vibrator/dynamotor psu for the 19 set. You don't have to worry about the tubes/valves. The normal psu uses a 0Z4 rectifier. The specs of the Rectifier#1 states that it works from 90V to 135V using inductors to regulate voltage but I'm not sure how well it works, as stated there are a lot of dead ones out there. The photo shows the rectifier #1 in use here. Last edited by Bruce MacMillan; 22-12-16 at 19:20. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wireless of the Week - week 20 | Bruce Parker (RIP) | The Wireless Forum | 5 | 16-08-20 18:16 |
| Wireless of the Week - week 5 | Bruce Parker (RIP) | The Wireless Forum | 20 | 26-12-19 23:39 |
| Wireless of the Week - week 6 | Bruce Parker (RIP) | The Wireless Forum | 11 | 21-08-16 15:30 |
| Wireless of the Week - week 7 | Bruce Parker (RIP) | The Wireless Forum | 3 | 17-07-16 00:47 |
| Wireless of the Week - week 8 | Bruce Parker (RIP) | The Wireless Forum | 5 | 10-04-16 00:24 |
Threaded Mode