|
|
|
|
#1
13-11-16, 21:42
|
|||
|
|||
Hi, may I ask anyone for outside diameter of oil cooler (incl. cooling fins) and also for the width and height of the whole cooler (rectangle)?
I assume from the above that inner diameter of pipe is 1/2. Many thanks for help in advance!
__________________
UCw Mk.III 
|
|
#2
14-11-16, 00:13
|
||||
|
||||
|
Early carriers had two pipes running through the cooler, later carriers had one single pipe, unsure of diameter though.
I recently learned this !
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration).
|
|
#3
14-11-16, 01:06
|
|||
|
|||
|
The threaded ends are 1/2" BSP parallel thread The pipes use Rotherham fittings (I think that's what they're called)
Some were made with the wire loops and later with the discs. The 2 runs of copper pipe are half inch o.d and they sweat into a casting with the fittings (screwed??) into the bottom that the pipes connect to. The outer fitting sits lower than the inner. I will post some photos later.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions....
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
