|
|
|
|
#1
31-10-16, 20:25
|
||||
|
||||
Hi Chris
The 1941 dated container measures the following 20-3/4" wide 14-3/4" deep 16" high to bottom of lid The lid is 1-1/2" thick. Each hinge section 1-1/4" wide by 6" long. They are attached via a combination of slotted domed screws and hex bolts. They have also been leaded. I'm assuming to keep them sealed? The D rings are 2-3/4" wide. The clip holding them is 1-3/4" wide by 2-1/2" long. There is two D rings on the back panel only. The are riveted with 3 rivets. From the edge of the box to the outside edge of the clip it is 1-3/4". From the bottom of the box to bottom of the clip it is 10-3/4". There is a small data tag 2-3/4" x 1-1/2" riveted centrally on the lid A grab handle is riveted on each end of the box. The ring is 5-1/2" wide by 2-1/2". The bracket is 4-7/8" wide by approx 4" tall.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer Last edited by Jordan Baker; 31-10-16 at 20:32. 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
