|
|
|
|
#1
26-03-16, 23:22
|
|||
|
|||
early HUP seats
Hi James,
Yes, the three-quarter bench seat with reversible back rest is used in the front of the rear compartment. It is offset to the right a bit (how much I don't know exactly) to accommodate entry into the rear where there were 2 removeable seats similar to the seats in the cab. I will try to find some measurements for you. Brian
__________________
1942 Willys MB Jeep 505 contract 1943 C8A HUP 
|
|
#2
26-03-16, 23:42
|
|||
|
|||
|
more - measurements
James,
The front of the bench seat is 23 1/2" (measured on the floor) from the divider behind the seats up front. The amount of the side to side offset is 6", i.e. the seat is located 6'' closer to the driver's side than to the co-driver's side. Hope this helps. Cheers, Brian
__________________
1942 Willys MB Jeep 505 contract 1943 C8A HUP
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wanted: Carrier seats | RichardT10829 | For Sale Or Wanted | 2 | 29-05-14 09:33 |
| Wanted: Seats | Shane | For Sale Or Wanted | 0 | 26-12-13 01:42 |
| Seats | gary_bath_jr | The Softskin Forum | 6 | 19-06-12 06:24 |
| Seats for C15 | gary_bath_jr | The Restoration Forum | 9 | 18-05-12 22:09 |
| CMP Seats | Jordan Baker | The Softskin Forum | 9 | 03-08-06 05:27 |
Hybrid Mode
