![]() |
|
#1
|
|||
|
|||
![]()
Nice work, flying along. The ads on hoses should be standard BSP, common size even even over there. Waiting for my two carriers from NZ now!
__________________
BETTER TO BURN OUT THAN FADE AWAY. |
#2
|
||||
|
||||
![]()
Looking good, glad to see another carrier coming along, Paul did you buy the 2 carriers from "Mark" NZ that have been listed recently?
__________________
39 Austin 8 Tourer 42 Humber Heavy Utility 42 C15A Wireless Truck 43 Humber AC MK IV F133744 "Vandal" tri-owner 43 A27L Centaur MK III T185481 Last edited by lssah2025; 16-01-16 at 18:09. |
#3
|
|||
|
|||
![]()
As I have had some PMs regarding my recent posts I edited the one on the oil cooler lines on the lengths of the hoses. Also here is the measurements of the ball/sleeve on the Exhaust down pipes so you can get some made up for your project. Just a side note that if the cast L bows in the floor were new it should be 1 1/2" ID but with mine i found that they were both different in sizes and I got the Sleeves custom machined to fit each side as I found that they can be as much as .070 larger ID.
|
#4
|
|||
|
|||
![]()
Well I had a pretty good week overall and I got all of the conduit installed as well as the wiring. The rear engine compartment is now all wired and hooked up, Installed the rad and I was able to install the frame work around it as well as the rad side covers. This coming week I have some more fabrication to do as I have to make up some engine covers as well as a few more pieces.
|
#5
|
|||
|
|||
![]()
A few more pictures.
I also installed the air cleaner and tube to the carb as well as the overflow tube from the rad. |
#6
|
|||
|
|||
![]()
I got this decal from I believe Derk and does anyone know where it goes IE the side or top, Left side or right side of the air cleaner
![]() |
#7
|
|||
|
|||
![]()
Dave, Great work and great photos. They will help me and I'm sure, a few others as well. There's a lota bits in there!
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... |
#8
|
||||
|
||||
![]()
I see Dirk has those and also a 'yellow' one with 'Made in Canada'. Would the Yellow one be correct for my MK2? Ron
|
![]() |
Thread Tools | |
Display Modes | |
|
|