|
|
#14
13-04-03, 03:54
|
|||
|
|||
wheelie good fun
wheels interchanged- to make it work i have replaced the roller bearings with tapered roller bearings, made a new seal holder for the inside seal & deleted the bearing spacer- adjustment is by tightening up the hub nut until there is no play & then tighten until the next split pin hole is uncovered. fit a split pin & viola- front wheel. next challenge- to make the brake/steer rods end yokes........
rob 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode