MLU FORUM  

Go Back   MLU FORUM > MILITARY VEHICLES > The Restoration Forum

Notices

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 25-07-15, 23:40
Lynn Eades Lynn Eades is offline
Bluebell
 
Join Date: May 2003
Location: Tauranga, New Zealand
Posts: 5,541
Default

Bruce, the soft iron pole shoes are the magnets which are energised by current flowing in the field windings. These pole shoes hold residual magnetism. The polarity is easily set up and just as easily reversed.
To polarise the generator, all it requires is to run a wire from the live battery terminal (in the vehicle the geny is to be fitted into) to the field terminal (wire)of the geny. Striking the wire onto the "F" terminal a couple of times will do the job.(expect little sparks)
The process of testing and rebuilding a generator sometimes results in the polarity being reversed. The unit you get back may not have been your one and also may have come from a vehicle that had a different polarity to your veh. This is why it needs to be polarised for your particular vehicle.

BTW, this "residual magnetism" is what voltage "builds" from, when you tow start a vehicle with a dead battery. If you can get the generator turning over fast enough, it will produce enough voltage to fire the ignition. If you keep the revs up the geny will not only produce enough to "fire" the ignition as well as put some charge into the battery.

You cannot do this with a vehicle fitted with an alternator because the design is different and an alternator requires battery voltage to "exite" it. (get the charging started)

Dave, Does you ign. warning light go? If it goes, there must be a complete circuit. I don't have enough knowledge to help you from here.

ASK an auto electrician if you can do this;
What happens if you momentarily touch a wire from the "F" terminal to to the battery? (engine running above idle)
This would be an un regulated generator which will deliver 30 to 50 volts (the geny wont last long at this out put) The field strength regulates the out put.

Does the generator start working? You should be able to detect the engine loading up.
If it then works, I'd say it is the cutout at fault.

Be careful, those are good bits until the smoke gets out of them. Once the smoke gets out, you'll need new bits.
I don't want to cause that.
__________________
Bluebell

Carrier Armoured O.P. No1 Mk3 W. T84991
Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6.
Dodge WC55. 37mm Gun Motor Carriage M6
Jeep Mb #135668
So many questions....
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
charging set Mike K Auction and Classified Ad Site Heads Up 10 23-10-12 20:33
Charging Board jason meade The Wireless Forum 5 19-05-12 18:47
Wtb: A CHARGING BOARD FOR A NO.19 SET Doug Lavoie For Sale Or Wanted 13 09-02-10 02:11
19 set complete plus charging set malcolm erik bogaert For Sale Or Wanted 0 13-10-08 13:27
Charging Set Darren Witty WW2 Military History & Equipment 4 06-07-08 04:39


All times are GMT +2. The time now is 23:04.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016