|
|
#8
24-07-15, 10:03
|
|||
|
|||
The gasket (part # BB-40350 that goes between the two halves of the rear axle is ).010" (10 thou) or in metric 0.25mm
The thickness is important because it sets the side bearing preload. There is a list of bearings with Timken and Ford cross over in the other carrier hints thread.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carrier Assembly; Helpful hints, tricks and traps | Lynn Eades | The Carrier Forum | 19 | 25-11-24 05:27 |
| My first carrier: some assembly required | super dave | The Carrier Forum | 207 | 24-03-17 22:52 |
| Wanted: Carrier Radiator Cap Bellows Assembly | Lynn Eades | For Sale Or Wanted | 8 | 12-11-13 13:40 |
| Carrier tow chain and wire assembly | andrew honychurch | The Carrier Forum | 4 | 17-06-12 08:51 |
| Wanted: LP2/2A Carrier Brake Spindle Assembly | Ian Patrick | The Carrier Forum | 0 | 13-05-11 00:02 |
Threaded Mode