11 Set stuff

[Mike K]

I spotted a Ebonite B base from the golf bag set at the recent hamfest . It was $10 and I didn't buy it as I already have two of them . The seller of that B base is a regular attendee at hamfests and I could possibly buy it for somebody .

[Tim Bell]

For the WS11 fans... two previously unpublished pictures from an album I have of Canadian Wireless operators training with the WS11 at Aldershot.

Aldershot-WS11-1.jpg

Aldershot-WS11-2.jpg

Hope these are of interest.

Tim

[Chris Suslowicz]

Originally Posted by Ron Pier

Well I'm not sure where I'm at!!! I've posted stuff to Canada and sent emails to Kent and not had a jot of response. It's definitely not the way I deal with people. But worse things have happened to me so I'm sure I'll survive it. Ron

Um, I've sent stuff to Canada and got a reply (recipient was a very happy bunny), and I've received (and replied to) your emails. Is your ISP on the blink?

[Ron Pier]

Apologies Chris if your not getting through for some reason. I've sent you emails on 7th, 9th and 15th April but nothing back??? Ron

[Chris Suslowicz]

Originally Posted by Ron Pier

Apologies Chris if your not getting through for some reason. I've sent you emails on 7th, 9th and 15th April but nothing back??? Ron

Check your spam filter? (Or complain to your ISP, as it looks like they're being silently dropped - I've had no bounce or rejection messages.


R Ron Pier 7/4/15, 06:52 +0100 4 11 Set
• Chris Suslowicz 7/4/15, 08:57 +0100 2 Re: 11 Set
* Ron Pier 9/4/15, 13:50 +0100 4 11 set
• Chris Suslowicz 9/4/15, 13:55 +0100 2 Re: 11 Set
• Ron Pier Wednesday, 05:37 +0100 4 11 set
* Chris Suslowicz Wednesday, 10:04 +0100 2 Re: 11 set

Chris.

[Ron Pier]

Well I'm back onto my switch panel after receiving my switch finger plates back from my local friendly engineer who milled them to size for me.
I borrowed Dave's idea of printing a paper version in negative.....which took some mucking around with my scanner to get to actual size. Then jig sawed the openings for the switches and a down light cutter for the gauges. I'm waiting for some brass BA screws and nuts to arrive before I can continue. But very pleased so far. I'm using a piece of black Bakelite for the panel. Ron

[Ron Pier]

Next faze was to put the cut outs in the bottom of the cabinet where the cables pass through, rivet the hinges on in readiness for the doors (yet to make) and weld on the brackets that hold the panel (which I've now fitted up some more with my new BA screws). I also drilled and tapped the panel brackets for 2BA screws as not knowing what they where originally, I just did it with a size that I have in stock. I'm in need of some period looking cable if anyone has some they'd like to sell. Ron