Images of the radio battery box interior

[kosbie]

Hi Ritchie
Don't know if this helps but I have attached some photos of my battery box, including the underneath. Not as clear as it might be as not blasted yet. The bar for the rods that takes the wing nuts is riveted at its outer ends then tapped for the rod inboard of this. The photo of underneath might help. If you want me to measure anything let me know
Rick Overy

[RichardT10829]

Cheers Rick.

I cannot see any pics ?

[kosbie]

Sorry, technology defeats me every time. I think the file size is too big?
I will have to get my kids to help me out
Rick

[kosbie]

Pics should be attached now?
Rick

[RichardT10829]

Excellent thanks very much

[RichardT10829]

I have mocked up the basic walls of the box onto the hull, can anyone tell me what the measurement is from the edge of the sidewall of the box up to the top of the rear armour is ? Just so I can set my height before fishing fully ?







I still have to trim the angle iron etc etc... It's very rough at the moment.

[Ben]

Looking good. The scout sits flush with the centre height so I can't really help, I can measure as best I can to the side but it wouldn't be perfect. I'm sure someone with a UC will be along soon. Nice to see the rear plate is a touch taller as it should be, allows the lid to be flush once down on the sides.