UC MK.II* Canadian armor thread

[Radek]

1:4

[eddy8men]

thanks, we are all in together until the bitter end

rick

[RichardT10829]

right that's better...feel like I am steeling Hanno's Thunder here (he is forum plod)

I can measure my plates but they are mk1 and repro.

I am trying to boot up an old PC to get the bulkhead and side armour drawings for a few people... Do you have side armour ?

[Hanno Spoelstra]

Originally Posted by RichardT10829

right that's better...feel like I am steeling Hanno's Thunder here (he is forum plod)

In Holland the police is one's best friend, or so they say

Let's keep this in the right prespective guys, it's a matter of giving and taking having to be in balance. So Eddy & Richie, take out those measuring tapes and help Radek with his much needed measurements

PS: while you are at it, Siemon is in need of some measurements as well

Thanks,
Hanno

[RichardT10829]

Like I say mine is repro, and I had no reference when unmade the section but here goes

I have to upload them off site as I am using apple products























Like I say could be wrong but I made it work.

I still need to put the fillet in on the upright angle bar as you can see it's missing

[Radek]

Richard,

thanks. That will be helpfull, but I don´t know if is this part the same by MkI and MkII.
Could somebody confirm, that the whole on the Richards pictures is only round without thread?

Thanks

[Jordan Baker]

The hole in the front plate should be threaded. The screw has a shoulder on it and this is what the swinging plate pivots off of. The head of the screw is not flush with the front of the swinging plate.

[Radek]

[Radek]

Richard,

Yes I have cca 97% lenght of side armors and rest measured on another UC.