|
|
#9
23-03-14, 05:22
|
|||
|
|||
I did a fair bit of work on the Lynx in the Shilo collection. For the most part, the Lynx is not that different from working on a truck of that vintage. It is one of my favorite vehicles to drive out of the collection, and that says a lot. Hopefully a Lynx is in my future, but then again I have so many projects underway now I don't know in which decade I would fit it in.
Unless you happen to find a frame somewhere, I would suggest removing the hull and fishplating/welding the frame. I think the hull will add a lot of structural integrity to the frame, even if it wasn't 100% up to scratch. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lynx Hull number? | James Gosling | The Armour Forum | 3 | 17-08-15 08:28 |
| At last here are some photos NZ LP hull | Lew Skelton | The Carrier Forum | 12 | 29-04-11 10:22 |
| Hull # | gary_bath_jr | The Carrier Forum | 5 | 12-07-10 20:31 |
| Welded hull | martyn | The Carrier Forum | 14 | 15-03-10 13:02 |
| UC Hull | Richard Coutts-Smith | The Carrier Forum | 14 | 08-04-08 01:25 |
Threaded Mode