MLU FORUM  

Go Back   MLU FORUM > MILITARY VEHICLES > The Carrier Forum

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 09-03-14, 13:13
Lynn Eades Lynn Eades is offline
Bluebell
 
Join Date: May 2003
Location: Tauranga, New Zealand
Posts: 5,541
Default

Hi Petr (correct this time) that is the one. The cover for the cables beside the driver.
Have you established where your carrier was made yet? (Canada or U.K.)
I would like to see a photo of the engine bed rails.
__________________
Bluebell

Carrier Armoured O.P. No1 Mk3 W. T84991
Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6.
Dodge WC55. 37mm Gun Motor Carriage M6
Jeep Mb #135668
So many questions....
Reply With Quote
  #2  
Old 09-03-14, 13:31
Petr Brezina Petr Brezina is offline
Registered User
 
Join Date: Mar 2014
Location: Czech Republic
Posts: 547
Default

I see, sorry, dont get it. Pic added. I would say its UK made.
Attached Images
File Type: jpg bay.jpg (118.2 KB, 82 views)
__________________
UCw Mk.III
Reply With Quote
  #3  
Old 09-03-14, 23:04
Petr Brezina Petr Brezina is offline
Registered User
 
Join Date: Mar 2014
Location: Czech Republic
Posts: 547
Default

Done. Must say it again - this carb is just beautiful piece of engineering. Im looking forward to the connecting and setting
Attached Images
File Type: jpg carb6.jpg (42.4 KB, 23 views)
__________________
UCw Mk.III
Reply With Quote
  #4  
Old 10-03-14, 01:14
Lynn Eades Lynn Eades is offline
Bluebell
 
Join Date: May 2003
Location: Tauranga, New Zealand
Posts: 5,541
Default

Petr, that is the style of construction of the British carriers.
The engine bed rails are made from "channel" and have sharp outer edges. The Canadian bed rails have a rolled edge and are pressed from flat steel.
This difference makes any carrier immediately identifiable, as to it's origin.
As Michael R earlier said "British built"
__________________
Bluebell

Carrier Armoured O.P. No1 Mk3 W. T84991
Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6.
Dodge WC55. 37mm Gun Motor Carriage M6
Jeep Mb #135668
So many questions....
Reply With Quote
  #5  
Old 12-03-14, 14:07
Petr Brezina Petr Brezina is offline
Registered User
 
Join Date: Mar 2014
Location: Czech Republic
Posts: 547
Default

Lynn:
Nigel Watson: Few details of the back shelf (I suppose its original) and Stacey attachement mounting. Hope you will find it interesting.
Attached Images
File Type: jpg DSC_6493.jpg (100.6 KB, 31 views)
File Type: jpg DSC_6494.jpg (98.5 KB, 36 views)
File Type: jpg DSC_6495.jpg (99.4 KB, 36 views)
File Type: jpg DSC_6582.jpg (99.4 KB, 43 views)
__________________
UCw Mk.III
Reply With Quote
  #6  
Old 12-03-14, 15:09
Lynn Eades Lynn Eades is offline
Bluebell
 
Join Date: May 2003
Location: Tauranga, New Zealand
Posts: 5,541
Default

Petr, does the top (rear) deck fit, up the other way, with all the bolt holes lining up? Is it original?
My AOP has a deck that is higher than a MkI Universal, and so has no need for the mesh guards over the exhaust pipes.
The two square holes in the rear hull plate have a duct around them that turns the hot air through 90 degrees and goes up through the rear deck like a chimney.
This duct is sealed against the rear hull plate and against the underside of the rear deck. It would allow the carrier to wade deeper than the earlier U.C.
I have built mine wrong as it is only in the last few years that I have learned this.
If you have Nigels books (Very good books!) you will be able to check out the rear of the AOPMkIIIW
Do you have the data plate for her? If so what is the T number?
__________________
Bluebell

Carrier Armoured O.P. No1 Mk3 W. T84991
Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6.
Dodge WC55. 37mm Gun Motor Carriage M6
Jeep Mb #135668
So many questions....
Reply With Quote
  #7  
Old 12-03-14, 16:28
Petr Brezina Petr Brezina is offline
Registered User
 
Join Date: Mar 2014
Location: Czech Republic
Posts: 547
Default

Lynn, as far as I know, all holes fits each other and are lined up (its not placed properly on the picture No.4). I would still say it's original.
There are no square holes in the rear hull plate (see pic.)
No unfortunately I don't have these books yet, because Vol.2 (which would be most useful for me I guess) is not available now. But checking ebay etc. regulary
She's totaly "mystery lady" - no data plate, no T number, there are even no hull numbers present (on the common places). Definitely was built in late 44-45, most parts have a code "BMB" on it (if it can say something) and that's all...
Attached Images
File Type: jpg back.jpg (98.7 KB, 35 views)
__________________
UCw Mk.III
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
New Project ron The Carrier Forum 3 17-07-17 22:00
A new project Tim Lovelock The Softskin Forum 15 17-07-12 13:58
FGT project Tony Wheeler The Restoration Forum 38 12-07-12 06:09
Project F15 Howard The Softskin Forum 162 07-02-09 07:47
FOR SALE/TRADE: 1944 CHOREHORSE PROJECT for Signal Corps Wireless Power Unit Project Alain For Sale Or Wanted 1 21-02-07 00:11


All times are GMT +2. The time now is 10:17.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016