![]() |
|
#1
|
|||
|
|||
![]()
Middle Seat Left Side
1 Left Mid Rifle Clip & But Holder CMP.jpg 2 Left Mid Rifle Clip & But Holder CMP.jpg 3 Left Mid Rifle Clip & But Holder CMP.jpg I assume that the earlier HUPs with mid doors on both sides that the right side mount would be the mirror of the left. Middle Seat Right Side On HUP with no right mid door having the spare tire carrier in that location instead. 1 Right Mid Rifle Clip & But Holder CMP.jpg
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com |
#2
|
|||
|
|||
![]()
Right Rear Rifle Cup Mounting Holes
1 Right Rear Rifle Clip & But Holder CMP.jpg Left Rear Rifle Cup Mounting Holes 1 Left Rear Rifle Clip & But Holder CMP.jpg Does this provide the information you needed? I can post larger higher resolution versions of these photos if they would help or give you basic dimensions to locate the holes. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com |
#3
|
|||
|
|||
![]()
yes, realy thanks for that , it explains everyting .
The wooden blocks in a regular cab are in line with the vehicle , and I noticed on the hup they are under an angle . building year from this hup must be 43 . no data plate. 2 side doors , rectangular roof hatch , round instruments , hard rubber steering wheel. again thanks for info . |
#4
|
|||
|
|||
![]()
Thanks , brackets aree fitted.
Another question , were are the sidescreens stowed when not in use? |
#5
|
|||
|
|||
![]()
Hi Maurice,
The sidescreens are stowed in the wire mesh bins shown in the picture in post #6 from Phil Waterman. Cheers, Brian |
#6
|
|||
|
|||
![]()
Hi Maurice
Do you need photos of the rack and the mounting points? Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com |
#7
|
|||
|
|||
![]()
Phil thanks , but one of the side bins is still there , just the bottom piece is missing , but from the pictures in this post I can figure them out .and will copy one for the other side,
By the way the floor is made from checker plate , not the type as in the pictures in this post . Next bit will be the 1 gallon can holders for under the rear of the body , when these are done the body can go on the finished chassis . Are there drawings available from these holders?I have seen copies in the past in France. Will take some pictures next week . The vehicle base collor is Brown , scratched paint away on the front , and there seem to be remains of markings there , will try to save them . |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
M152 Interior Layout | Jason Ginn | Post-war Military Vehicles | 9 | 10-11-10 17:29 |
Carrier Interior | kevin powles | The Carrier Forum | 1 | 20-08-09 13:17 |
WD Interior Lamps | Richard Farrant | For Sale Or Wanted | 23 | 20-10-06 12:45 |
UC Grenade Box Interior | rob love | The Carrier Forum | 7 | 13-04-06 05:09 |
CMP Cab 12 interior | Steve Guthrie | The Softskin Forum | 10 | 03-04-05 17:53 |