|
|
#25
27-12-13, 12:58
|
|||
|
|||
Go to my thread "Control Rods Riveted U.C." It tells you how long and how much thread. Do them on a lathe (rod in the chuck and carefully supported) Square the die stock with the tailstock. The rod is medium tensile 7/16".
Both sides are the same length. To do your lower engine rail, it would help heaps if you can borrow one. Does this pic help? (It is an AOP sorry)
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode