|
|
|
|
#1
16-11-13, 07:55
|
||||
|
||||
I also had to replace a top section of the pillar that holds the windscreen on. That was really bad
|
|
#2
16-11-13, 07:58
|
||||
|
||||
|
After careful consideration I decided to cut up a CJ5 jeep bonnet as the shape was similar,(sort of)
|
|
#3
16-11-13, 08:00
|
||||
|
||||
|
A lot of hammering to get the shape I wanted.
|
|
#4
16-11-13, 08:05
|
||||
|
||||
|
I'm relatively happy the way it turned out and that was the worse part of this cab. I'm glad it's not a bus
|
|
#5
16-11-13, 10:35
|
|||
|
|||
|
Cab
Coming along nicely Colin. I always enjoy this sort of work on soft skin vehicles. A bit more challenging than cutting out flat steel plate when doing armoured vehicle repairs.
|
|
#6
16-11-13, 13:22
|
||||
|
||||
|
Colin,
you are a modest man with some very nice tools and a good degree of talent on hand. You make what others would struggle a life time to achieve look like a walk in the park. Nice work, grand job  R
|
|
#7
17-11-13, 08:40
|
||||
|
||||
|
Neville, it is a lot more challenging than doing flat plate steel and just so easy to blow a hole with the welder. All good practice though.
Thankyou Craig! I think I have a lot more determination than talent. I got a little bit more done this afternoon. I had to remake one of the heater channels that go under the dash.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
