|
|
#3
18-09-13, 20:46
|
||||
|
||||
Yep, brass 1/2 inch diameter drift used with a light mallet or hammer. Be sure to tap alternating edges from the back side and the bearing race will slide right out with ease along with the bearing and seals if still installed.
Lots of paper towels on hand and use of latex gloves makes it a cleaner job as well.
__________________
David Gordon - MVPA # 15292 '41 Willys MB British Airborne Jeep '42 Excelsior Welbike Mark I '43 BSA Folding Military Bicycle '44 Orme-Evans Airborne Trailer No. 1 Mk. II '44 Airborne 100-Gallon Water Bowser Trailer '44 Jowett Cars 4.2-Inch Towed Mortar '44 Daimler Scout Car Mark II '45 Studebaker M29C Weasel 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Outer Wheel Bearings | gary_bath_jr | The Softskin Forum | 28 | 26-09-12 13:01 |
| carrier wheel bearings, t16 axle brakes and sprockets | Hans Mulder | The Carrier Forum | 13 | 13-06-11 18:14 |
| Wheel Bearings | Bob Moseley (RIP) | Parts/Sources/Prices | 0 | 18-02-08 13:21 |
| F.S. NOS G166 Outter Wheel Bearings | Tom Wolboldt | For Sale Or Wanted | 0 | 14-03-06 13:30 |
| Road Wheel re rubbering | Robin Craig | The Carrier Forum | 1 | 17-01-06 09:28 |
Threaded Mode