Wanted: Chevrolet Kingpin Shims? C8 ...need a few extra

[Alex van de Wetering]

Hi Hanno,

Thanks, I was just looking at VW t2 shims a few days ago...both kingpin shims and generator shims, but I couldn't find any measurements anywhere. The ratio between inner and outer diameter seems to be about the same on some of the VW beetle or transporter shims, but I just don't know what the actual size is. I looked for a VW parts expert here close to Schiphol so I could just drive over and compare the shims, but couldn't find any dealer close (?).

[Lynn Eades]

What about cutting them?

[Rob Dyba]

Good advice- go to your local engine parts supplier, and ask for a pack of shim steel. You usually get 5 sheets, 200mm x 200mm in various thickness and you can use gasket punches and sizzors. Perfect for gearbox shimming, kingpins, ball joints, steering boxes, p/steer pumps, steering racks. ... I make all my own shims when there is none to hand.....

Rob

[Alex van de Wetering]

Lynn, Rob,

I went with your suggestions; I cut a few shims from 0,4mm stainless and fitted the axle last weekend. All overshadowed when I cracked the master cylinder casting shortly thereafter.
Anyway, thanks and I will post some pics in a few days hopefully.

Alex