Scout T5329

[Ben]

I've been a little lazy with updates so here goes.

The engine cover on a pre universal carrier is a little different. The one on the Scout angles down from the air box until it reaches the rear section, it then levels out to horizontal. The Scout still has its original frame and a couple of the cover panels. Years ago a small section was cut out with a torch to allow a little movement for the engine to come out easier leaving the air boxes in place. After i'd straightened a couple of parts i jigged it all together and welded in the missing sections, they're only a couple of inches long maximum. I'll tidy the welds up when i take the frame out.

The photos show the lower rear section and the early type curved air boxes. The fittings on the upper panel are one of the pogo clips, two latches for the side armour and the Butt rest for the Bren if its in the LH side engine cover pintle.