CMP differences: Ford vs Chevrolet

[Svenn Ryen]

Hi guys.

Thanks for the replies.

Heres a picture of the fire-ext bracket i mounted in the holes on my back panel. The holes are not custom drilled out, but factory made, I am 100% sure!


Could be a water truck issue?? Could bracket have been mounted on the outside?


Svenn

[Svenn Ryen]

Hi David...dont blame your age for seeing the rifle brackets when not having some size references.


Heres is a scetch of what i found on the F60 i got some parts from. All holes looked factory done.

And heres som Pictures of the clamps....showing the crank in them and a special picture for you David together with the rifle bracket

The little plate was for getting all clamps at same "level".

Svenn

[Svenn Ryen]

BTW- any drawings for the Storage bags available?


Svenn

[serge]

Hello

I use the opportunity of these thread to ask you a question about the parts used to held the upper of gun.
I am actually restoring a HUP and some of these parts are very rusty and I have observed that the coat of paint is very deep as showed in the associated pic.
I am sure that it is not "normal" paint but what is the coat used?

Regards Serge

[serge]

Hello

In my previous post , I have writen an erroneous word about the parts helding the upper part of gun.
I would say about the paint that these one was very thick so I think that it is a special paint but what kind ???
To answer to the post of SVEN I join a pic of the fire extinghuish of my F60L and the holes match with the bracket. This one is situated behind the driver chair.
I join also a pic of the bracket for upper part of gun (F60L) which is different of those used on F15.

[Svenn Ryen]

Looked through my pictures.

Found this picture of a 43 model C15. It has the holes for the fire ext as well. It had the spare wheel carrier - so no room for a bracket on the outside.

Svenn