|
|
|
|
#1
06-03-13, 20:24
|
|||
|
|||
Is anyone doing a similar service in North America?
|
|
#3
06-03-13, 22:58
|
|||
|
|||
|
Bravo! Very good lookign wheels!
But I shudder at the cost to send dead wheels over and redone wheels back across the ocean.... Did you do the re-rubber, or did you take them to a shop? I have ehard a shop that re-rubber's wheels for forklifts could do this. CHeers, Jim
|
|
#4
07-03-13, 03:57
|
||||
|
||||
|
Re-Rubbering
Hi all - it is quite simple. Firstly identify an industrial rubber facility and get a mold made using a wheel as a template. My mold cost about $3000 to make and what happens is that the stripped rim is placed in the mold and then rubber is molded to it under a 600 ton press. My rubber has a Duro rating of about 75 which is more than adequate.
Bob
__________________
Chevrolet Blitz Half-Track Replica - Finished and Running Ford F15 - unrestored Ford F15A X 2 - unrestored Website owner - salesmanbob.com
|
|
#5
09-03-13, 15:47
|
||||
|
||||
|
the rim was stripped and they moulded polyurethane on it,after that it was machined to make it round.
the normal rubber is about 85 shore,the polyurethane is 80,that is similar too 85 shore rubber,so they told me.
|
|
#6
09-03-13, 20:15
|
||||
|
||||
|
Roy how many miles have you had out of the polyurethane ? I can get them done here fairly cheap but was unsure of the lifespan of the rubber.
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration).
|
|
#7
11-03-13, 22:23
|
||||
|
||||
|
richard
with our carrier not many miles,but the guy who did it for us told me he made lots of wheels for old tractor,s and he never had problems with it , also the ones he made 15 years ago look at this time very nice. the compound is the same as they use on forklifts
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
