|
|
|
|
#1
21-02-13, 16:07
|
|||
|
|||
SPAE-NAUR out of Kitchener, Ontario (I think), used to carry the two styles of cage nuts that Ford and Chev installed on their CMP front fenders. They also carried the correct fender welting with the proper bead, T-shaped windshield gaskets, exterior door handles for the Cab 11 and 12 CMP's, and the dual track felt channelling used in the Cab 13 sliding rear window assembly. Lift-the Dot fasteners and related installation tools were also in their catalogue. Might be worth looking into, if they are still around.
Good luck with your project. David 
|
|
#2
21-02-13, 18:02
|
|||
|
|||
|
Hi again.
Fastenal have most sizes. Do a search for weld nut - http://www.fastenal.com/web/search/p...eno=13&refine= Page 12- and 13 shows the sizes available. Svenn
|
|
#3
21-02-13, 20:23
|
|||
|
|||
|
That worked better
Hi Svenn
Yes "weld nut" gets all the sizes while "weldnut" only got the small three sizes. Check to see where I was buying them 100 each and it was Mac's and at that time they gave me a discount of the prices shown for ordering in quantity. Glad to find where they are in the Fastenal catalog because though their prices are often better (always better than the local hardware store) the guys in the stores don't really know what they have and if you can't give them the correct name they can't find stuff. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com
|
|
#4
23-02-13, 09:14
|
|||
|
|||
|
Here is a source for the special 1/4-20 cage nuts that goes in the front for the bolts for the grill, and at least for some plates in the cab as well.
http://www.thelongolivedrabline.com/...t-14-20-nc/302 Svenn
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
