Leaking seals 53 M38A1

[Bob Carriere]

Hi Casey

When you have a worn ridge smoothing down the ridges with emery paper or a flat file will help you install the sleeve...... I usually instal the yoke in a wood lathe 3 jaw chuck and spin at low speed while holding a flat file on the surface....finish with mid grit 3 M pad...... then you are aready to press the Speedy sleeve in place .... the sleeves are about the same price as a new bearing but works wonders. Did my T case and tranny......

Bob

[Casey B]

Thanks Bob! Good call will take it out this weekend and check to see what is there...all great words of advice...