Remanufacturing T16 Rear Box and exhaust shroud

[Ben]

That was kind of my point. If you said a single track link would cost £15 each as a raw casting plus a couple of pound each for machining, drilling then you needed the pins. The numbers get pretty big quite quick.

I think if you can get NOS track for £25 a link its probably a good but expensive buy!!! plus you'd be sure it worked. New track would be no cheaper IMHO.

Ben

[Lynn Eades]

Search a thread called "reproduction UC track availability)

At post #58 Wayne Henderson of western Australia has the original moulds for Australian track. There are pictures posted at #65.

A lot can be gleaned from this thread.
Could a Moderator move these few posts from Andrews thread, to that thread, and delete all but line 2 of this post