|
|
|
|
#1
26-03-12, 05:13
|
|||
|
|||
Lynn,
I am talking about the screws that hold the lower engine covers in place. The two I have are stamped TL 3596, FMCO 42 Perry Last edited by Perry Kitson; 26-03-12 at 05:22. 
|
|
#2
27-03-12, 17:34
|
|||
|
|||
|
I have a plain lower engine cover thumb screw that i'm going to take to the foundry to get a quote on. Could someone post a picture of a part number marked Canadian style original please. If the quote is good i will need to borrow it or a similar one to copy for a week or two.
Cheers Ben
|
|
#3
28-03-12, 00:17
|
|||
|
|||
|
I have a quote for the lower engine cover screws. It came in at $18-20 ea. These would be machined from steel round stock on a 8 axis CNC machine, and be supplied fully finished. This quote would be for a minimum 100 pieces. No part numbers stamped in. This is a little more than I had hoped ($12-14 was the figure I estimated). Any takers?
|
|
#4
28-03-12, 00:34
|
||||
|
||||
|
can you not just cast the thumb bit, drill it and then wind in some stud to make the threaded section ?
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration).
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
