Carrier Stainless Exhaust downpipes

[kevin powles]

Hi Jordan, I swung in a 24 stud canadian engine into the mortar carrier today. Your downpipes will fit, What you need to do is remove all four cast elbow 5/16" floor bolts, check you have the correct size gasket on the cast elbow floor flange, put in four descent bolts & nuts and leave them slack, Bolt your downpipe to the exhaust manifold up tight with the correct gasket, then tighten the four floor bolts, everything should pull into position.

I couldnt bolt the downpipe to the exhaust maifold as the bolts are sheared off in there. How are you sealing the down pipe to the floor casting?.

let me know how you get on.

kev

[kevin powles]

More pics.

kev.

[RichardT10829]

Now thats service.... not many folk would put an engine in a carrier to check stuff fits for a customer.... well done Kev.

Now.

What would i have to do to get access to one of those antenna mounts you got on the side of yer armour

[kevin powles]

Richard, No probs on checking stuff out, had to check as I thought I might be going mad , I have all the missing pieces on route to finish them anntena bases proper, Will lend one out when assembled complete. I have your old downpipe here for for you when you are next down.

[RichardT10829]

email sent matey...again though good crack that you have gone to the levels you have to make sure folk get sorted. Jordan I hope you get sorted matey

[Jordan Baker]

Ok thanks for the suggestions. I wasn't able to really loosen off the elbow bolts due to lack of room from the engine. However I was able to get a pry bar in there and put a lot of force on them untill the manifold bolts grabbed. I then kept prying and turning the bolts in a little at a time. Eventually they did pull in and everything lined up.

So for the next person that goes to install them. Make sure the elbow bolts are new and loose. Im sure its a case of having 2 (engine,elbows) of the 3 parts firmly fastend down. Whereas if I had all 3 parts loose it should go in no problem.

Thanks for checking it today with you other carrier. I am very happy to have them and not have had to go with the flex pipe and clamps. Thanks for taking the time to make them.

[Lynn Eades]

Is the problem at the bottom end? Th ppe should be able to movein the bottom casting. It needs to be abe to move in and out freely, as well the pipe needds to be able to rotate somewhat on the ball end of the pipe. If this is not the case, the pipe will break, or worse, something else will. I think a small amout of clearance was part of the design as the fan would clear any gas leakage. The designers weren't as pc back then. I too want these pipes to work
I