|
|
#27
05-01-12, 22:56
|
||||
|
||||
so what steel would you recommend for the snap... ? high carbon i might go get a blank and turn one out... the snaps available for the gun i have only go up to 3/8 and i need 5/8. i did a cold test on a rivet tonight with the snap i have (3/8 brazier) and it was peening the rivet over all be it only slightly... this was with the compressor half charged and only 40 psi at the reg (so i was somewhat impressed) i should think it will squash a hot rivet ok.
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration). 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode