|
|
|
|
#1
10-11-11, 06:37
|
||||
|
||||
Sadly it isn't. The fuel lines are 1/4 BSP fittings, but the other side that goes into the fuel selector or the fuel pump are something else. I do know modern brake lines pieces you can buy at a hardward/automotive store fit fine. I tried a fittings place and they could match one or the other but not both on the same piece.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
#2
10-11-11, 07:26
|
|||
|
|||
|
Jordan
The other end is most likely 1/4 NPT then. If so, it will be slightly smaller in dia. If you check a ford manual for the fitting that goes into the petrol pump, it might verify that. I imagine there would be some demand, and somebody must make them.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... Last edited by Lynn Eades; 10-11-11 at 20:00.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
