carrier exhaust boxs

[Rene Pijper]

Originally Posted by kevin powles

Hi,
I am making some carrier exhaust boxs at the moment, I have both kinds of the original ones here (squared off and rounded top ones). I have the exhaust bafflers made up and am working on the pipe bends at the moment, I think I can knock them out for £200 a set of two which includes the long pipes back to the exhaust cast floor plates, so basically a complete exhaust system in mild steel. The long pipes would be welded to the bottom bend as per originals. Ideally these exhausts are best fitted with the rear axle removed but can be fitted with the axle in place if you remove the rear tool plate and have plenty of patience and ground clearance to twist them into position, (those who have done it know what I am talking about), last thing you want is to put a connecting clamp between the bottom bend and the straight pipe part. I will post some picks once I have the bends made and welded.

kevin.

Can you make for me a set
regards rene

[Rene Pijper]

can make for me a set
Regards Rene

[kevin powles]

Rene, check your private message in box.

kevin.

[kevin powles]

Hi

I have two sets of these carrier exhausts available, they are stainless pipe with mild steel silencer, they are complete pipes (welded, no joins) right back to the cast floor elbows as per the originals £300 a set.

uk only due to size.

Kevin.

[carrierbarry]

I brought a set from kevin some years back it fitted perfect.
Really well made, good product.

[RichardT10829]

i also used the same silencers on Kevin's recommendation and they work a treat, however i used stainless dairy pipe for the remainder of the system.