|
|
|
|
#1
02-05-11, 10:09
|
||||
|
||||
engine is canadian built 24 stud unit and was last serviced in 1945 so methinks it may be an earlier one.
the mains and big ends were on 010 thou and the bore is 030 oversize using a three ring piston. Lynn i will get some close ups. it is not the pin where the hole is mate, that is bit is ok  its up one side and has rotted through i could weld it up or tidy the mess into a nice hole for further drainage.....will most likely weld it though.i think i managed to reveal bits of the original paint which i can only describe as a very dark grey...may not be original but it was like a hard enamel and there was nothing else under it ?
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration). Last edited by RichardT10829; 02-05-11 at 10:18. 
|
|
#2
02-05-11, 10:45
|
||||
|
||||
   no lip on the top this may have been machined off at some point perhaps ?     
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration).
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
