![]() |
|
#1
|
||||
|
||||
![]()
I beleive that central hole on the bottom of the bin was only intended to be on the R.S. bin. The wireless installation instructions show that a hole needs to be drilled there so that a cable clip can be bolted underneath.
As for attaching the felt to the wood in the lid, I used the split rivets as shown. I did the head of the rivet in the felt and pushed the legs through the plywood. The two of them held the felt on very well.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer |
#2
|
|||
|
|||
![]()
My photo shows two thickness of felt. The screws would be 1/4 inch. They are countersunk screws.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... |
![]() |
Thread Tools | |
Display Modes | |
|
|