Oil Cooler elbows

[Jordan Baker]

So I went to install my oil cooler lines today. Had to go out and buy a 1/2 tube bender from Princess Auto. It works fine. However I collapsed one of the tube trying to get the bend tighter. I managed to get the short one installed. But the long one proved to be rather hard. The attachment point on the cooler sits lower and I found it very hard to get a tight enough bend to clear the bogie/suspension tube.

Do anyone have any photos of the lines connecting to the oil cooler itself and any suggestions to help me out with this.

Furthermore asking again if anyone has a set of the original elbows pictured above. The new made ones are too short.