WANTED: UC No2MkII* speedo driven gear

[Marc van Aalderen]

Originally Posted by BCA

Hi Marc,
If you mean the angle drive gear that clamps onto the speedometer then I have NOS ones in stock. Send me a PM.
This a cast fitting that the speedometer cable threads onto so you can attach the speedo cable to the speedometer. There must be properly greased and turn freely or the speedometer cable flexible shaft will break. This angle drive for Mk1 and M11 speedometers is diffrent than the T16 Carrier angle drive.
Brian

Hi Brian,

I didn't know that that is something I'm also missing. It does make sense as the space in the Dash is very limited so no room for the speedo cable to make a big radius bend. PM sent. Thank you.

Cheers, Marc

[Marc van Aalderen]

Hi Lynn and Richard,

You were both looking at the correct parts. I tried to find a picture of these parts in both workshop manual and Mk1* parts catalogue but there is absolutely nothing in either book. Then I looked in the later parts catalogue for Mk1* AND MkII*. This uses the same plate as the Mk1* parts catalogue but with the two items I need added! It shows the gear CTL2216 and housing CTL 2510 B2. So Richard, you were right there. !! Lynn's left picture says it all, they probably fail often...

Lynn or Richard, if nobody has NOS or used good parts for me can I borrow one of each part from either of you to have them made? I will off course return them after reproducing them.

BTW, Lynn the seal is also shown. Part number C01UC105387

Cheers,
Marc

[RichardT10829]

yes no problems buddy just keep me posted.