Sten Gun mounting

[Lynn Eades]

Can we have some pictures of what you have?

[Ron Pier]

Here is mine on my MK2. bolted to the engine top splash shield. I can take measurements if this is correct for yours. Ron

[charlie fitton]

to the inside so my veterans dont get hung up on them...

[kevin powles]

Hi, Thanks Ron, I want to mount a sten gun in the back of my tank hunter, I know as standard it wouldnt of had this facility but I have the clips and want to use them, i will take some pics later, The FUC-03 catalogue part number for them is C31UCW-104378 for both brackets but mine are slightly different.

I dont think the sten would look out of place on the tank hunter if mounted in a similiar postion as on the Mk2, I'm thinking they may of did this when the 2pdr was removed and they wanted to use it as a useful carrier, any thoughts on non stanadard stowage mods applied to carriers?.

Ron if you could let me know the spacing measurements between the clips, i think the T stock bracket is mounted at a slight angle looking at the parts drawing.

thanks kevin.

[Ron Pier]

Kev. The front bracket lies vertical to the ground. it's about 1/2" from the front and top of splash shield at the nearest points. The rear bracket is almost at the top of shield at nearest point and lies at an angle to suit the T butt. Distance between centres of brackets is 22 1/2". Ron

[kevin powles]

Hi, Ron many thanks for taking the time on the pictures, my brackets look like yours, just need to put some leather on them. I have a mK3 sten which I have just realized wont fit these brackets, I guess they were made for the Mk2 sten, as you have fitted. Anyone what to trade stens?.

Ron, Got the 3" mortar finished, many thanks for your help also in this area, interesting note is the training tube mortar which I have wont take a regular mortar bomb, it appers the training bombs are made smaller to fit the smaller inside diameter tube, not by much, I guess this is to stop your sticking a live HE mortar in the training tube and then taking a last look as it ski ramps out the bottom.

[horsa]

Hey Kevin,

Can you post a photo of your mortar training barrel and does it have any markings? All of the training barrels I've seen were made from either early WWII 3" barrels or modifed Stokes barrels. But either way, they accept a standard 3" mortar bomb. Practice loading bombs were standard rounds with sand for weight inside. And they usually have a large metal ring similar to a big washer welded to the bottom edge of the tail unit fins. That way they wouldn't get bent when the bomb came out of the cut-away lower section of the barrel after dropping it down.