|
|
|
|
#1
09-06-10, 22:21
|
|||
|
|||
sure will check it out when next at the workshop. The kit shown is what I am after, I will check out the supplier now thanks. Why did you go back to 6v Lynn? Originality?
|
|
#2
10-06-10, 08:30
|
|||
|
|||
|
Andrew
You mean Jordan
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions....
|
|
#3
10-06-10, 15:40
|
||||
|
||||
|
Went back to 6 volt for originality. I also rebuilt the dash panel once I got the original fuse holder and such. With the proper wiring and grounding it starts just as easily as the 12volt does.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer
|
|
#4
10-06-10, 21:08
|
|||
|
|||
|
ooops, yes I meant Jordan......please bear with me, I am trying to get to grips with everyone. I have to say, that the 6v coil, with a lovely Ford Script on the top, started the Carrier perfectly. But that said, it did have 12v running through it. Anyway, I have now destroyed it and taken it to bits to try to make a 12v system. basically, by filing off the rivets that hold the coil to the base plate you can seperate the two. Then you can scoop out the inards of the coil which leaves you space to connect up the low tension and high tension systems. I have not quite finished this "mock up" but I am sure it will work . I have planned to bolt the original 6v coil back onto the Distributor and run the new HT lead out of the side of it. If it works I will add some photos, but to be honest, its probably best just to buy one of the purpose built adapters.!
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
